Underground Cable Locating Tips

Cables are used to transmit electric power and it actually contains more electrical conductors and multiple wires. Usually, the cables for power transmission are buried underground and sometimes, they pass over the air. The cables should be strong enough to withstand the power passing, especially high voltage. If the wire is very weak, there may occur some explosions due to the leakage of electricity. Charleston cable fault locator is very much useful to detect any damage or fault in the cables. The identified faults are then fixed by means of the professionals available to carry out the installation and fixing of wires.

Fault locator for underground wires:

In general, there goes the underground wires and most of the people may not be aware of the presence of wires underground. The appropriate authority must take necessary arrangements in order to place the fault locator in the cables. Fixing the faults in wire is considered to be very difficult task and you need to be more careful to perform this task by means of the fault locator. The locator will have the capability to identify the faulty areas in the cable and give signals to the exact section so that available experts will come and fix the problem.

Detection devices with infrared technology:

Have you heard of any leak detection services? It may be water leak or thermal leak and you must be very careful in looking after those issues. Both thermal and water leaks at home are to be take care off with the help of new technological available in the market. Charleston leak detection devices for thermal leak uses infrared light technology and such devices help you to save a lot of money being spent from your pocket. Laser settings and other lights incorporated in the detection thermometer is there to find out the existing problems in the area.

Solution to Your problem:

Now a question arises that what should you do when fault arises in your cable. The best would be to call a professional electrician who can locate the cable and the breaks in it. The equipments needed to repair the faults are usually expensive so it is better you leave it to the professional. He will use a cable tester to locate the fault if any break exists.

After that he or she will locate the path of the wire using an underground cable locator. They now mark the places wherever the cable runs underground with paint. Using different methods he exactly locates the spot of the fault. That can be located by testing the voltage change in the ground. Earth gradient method is also applied many times in such situation. In the earth gradient method a high voltage is applied through the concerned cable and detected with help of a special kind of meter. These methods are very accurate if your underground cable specialist is well experienced.

Most of the leak detection device will find the leak by giving an alarm and the inbuilt sensor will be monitoring if there occurs leak anywhere in the pipeline. It would be good to get the assistance of plumbers in order to carry out the periodic checks of this water leak. Some of the areas where water leak is more will be lawn, water meter, bathroom and toilet areas, spa, pools, kitchen etc. Active and passive are the two main types of systems available for water detection and you need to be little careful with the passive device.


Leave a Reply

Your email address will not be published / Required fields are marked *